Products, Oil Filter Cutter

AFC-470-1 Oil Filter Cutter
Our cutter is the only one that will cut the new - Champion filters

Finally... An easy to use low cost oil filter cutter!


"The best oil filter cutter we have ever
 used is made by Airwolf Filter Corp."

Pete Bedell
AOPA Pilot Magazine
April 2000
 
  • Normal accepted practice is to cut your filter open at each and every oil change. This is "the" easiest way to immediately determine the health of your engine. Every A&P practices this ritual. No one wants to find metal in their oil filter, but it is far better to find out on the ground, than in the air.
  • The Airwolf AFC-470-1 oil filter cutter is constructed out of a solid billet of 6061T6 aluminum. Then we apply a thick layer of black hard coat anodizing to resist scratches and wear.
  • Specially designed razor sharp cutter wheel, hardened to 60 Rockwell, will slice the filter can open effortlessly. Cutter wheel is replaceable, but we doubt you will need one. Embry Riddle University just purchased their first replacement cutter wheel for an Airwolf Filter Cutter they have been using now for 3 years, cutting an average of 100 filters a month open. That's how tough our cutter wheel is.
  • The Airwolf oil filter cutter will weather the toughest of mechanic's operation. And, it is so easy to use, you can open up several filters in the same time as it takes to open one with the expensive Champion CT-470 cutter.  Not only does our cutter save you time, but you can get it for a fraction of the $200 Champion price. And, it is far better than the flimsy $49 cutters you might be tempted to buy.
  • Textron Lycoming in the recent Service Instruction SI-1492B, specifically recommends the use of the Airwolf AFC-470-1 cutter as a preferred method of opening up the oil filter to check for premature piston pin plug wear. If Lycoming is recommending it, you know it has to be good.
  • Guaranteed satisfaction. View it for 30 Days. If for any reason it does not meet your expectations, return it for a full refund.

$ 89.95

 

NOTE TO ALL OWNERS OF THE ORIGINAL AFC-470 OIL FILTER CUTTERS

When the major filter manufactures changed their oil filters to their new -1 filters a few years ago, they changed the thickness of the bottom of their filters can which can cause reduced life and or breaking of our cutter wheel.  While we are not pleased that the filter manufactures made this change, we had no choice but to come up with a solution for the thousands of cutters already out in the field.

We now offer an upgrade kit to convert our original AFC-470 cutters to the new AFC-470-1 style.  This upgrade kit is $49.99. It comes with everything needed for the upgrade. It will take about 30 minutes of your time to install the new parts and once done, no more cutter wheel breakage. The P/N is AFC-470-UPGRADE.